Models > ATC150JK1

ATC150JK1 Uni Refrigerator - Overview

Get Parts and Repair Help for ATC150JK1

If you know the refrigerator repair part you need, you can browse the list of all parts on the ATC150JK1, or you can search by name or part description. You can also find your part by where it is located on the ATC150JK1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ATC150JK1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.14

Door Shelf End Cap - Right Side

This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.

$3.43

Door Shelf End Cap - Left Side

$14.62

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$5.41

Hexagonal Screw

Sold individually.

$7.46

Light Socket

$3.43

Door Shelf End Cap - Left Side

$3.33

Door Shelf End Cap - Right Side

$2.52

Ice Cube Tray

Sold individually.

$7.68

Door Hinge Pin Bearing

This white hinge pin bearing pivots the freezer and refrigerator door.

$34.24

Fresh Food Door Gasket

This almond fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Light socket melted around bulb

  • Customer: William from Alexandria VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 27 of 47 people found this instruction helpful
After unsuccessfully trying to change the blown light bulb I discovered that the plastic light socket had gotten so hot that it melted and permanently fused with the blown bulb. After my new socket arrived in the mail I just popped the temp control assembly out with a screw driver and removed the old socket and placed the new one in. Whole operation to 5... read more

Drip pan had rusted & was leaking water on the floor

  • Customer: John from Forest VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Wrench(Adjustable)
  • 6 of 7 people found this instruction helpful
The BIG problem was getting the old drip pan off. The bolt on top of the compressor was too long to allow the removal of the old drip pan. I removed the old drip pan by cutting most of it away with tin shears then cutting the remaining part of the pan around the bolt with a hack saw (taking care not to damage freon lines and raising the pan above the threads... read more

Compressor was short cycling

  • Customer: Sherman from Tuttle OK
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 6 of 10 people found this instruction helpful
Removed the cowling with a square drive screw driver, removed the spring clip from the cover of the compressor controls with a screw driver, pulled off the old compressor start relay and replaced it with the new part. Since other problems could have caused the compressor to short cycle this was a "replace the part and hope it would work" since that would be ... read more