AS829FWWGB Maytag Refrigerator - Instructions

Unscrewed old filter and screwed in new filter.

First removed the old water filter and replaced it with the filter bypass. Very simple and no tools needed

The Ice maker unit had to be removed and the shaft had to also be removed, which required dis-assembling the motor drive. The thickness of the shaft and the bearing fill cup prevents it from simply pushing it in place. Other than that I have Ice.

Very easy to order from parts select. Took seconds to replace.

No tool required! Pulled out tray, emptied ice into large bowl for reuse. Pushed in and pulled from inside the coil springed auger until could get old plastic ring off and put new one on. Useing care not to apply too much pressure to ice dispensing end so as not to break housing. Have to turn auger assembly at an angle to compress enough and get old ring off. Needs a little physical strenth & care not to force plastic housing to breaking point. Worked great reused saved ice. Took less than 10 minutes

Replaced filter with by-pass plug. For some reason though, ice maker does no longer functions, although there is flow out of the cold water tap. Is the design of the bypass plug such that, when installed, it impedes flow to the ice-maker?

Thanks

Replace the refrigerator lightbulb while traveling 88 mph then turned on the flux capacitor being carful not to get stuck in a worm hole. This allows you to fix the problem before it starts to go bad.

Removed screws from upper hinge. Removed washer from door stopper on bottom hinge. Lifted door off lower hinge. Replaced bushing.

Took about 15 minutes and cost less than $12. Service call alone was going to be $70.

Viewed the repair video. Removed covering. Replaced limit switch, control board, and solenoid. Very easy repair!

I watched your online video on how to take out the old filter, and then to replace it with the new filter. It was as easy as on the video. Thanks!

Instructions were great five minutes to remove and replace fan....Thank You............ saved big money

I followed the video of your repair man. Made it very easy.Thanks.

It was only the door but it wouldn't come out without disassembly of the entire dispensing section; this meant removing the front section and disconnecting 2 pcs from 3 wire harnesses...much more involved than I thought. The spring and strike were fine, but when I reassembled the unit it didn't work. The key was the mechanical connection with the solenoid. It is not obvious and directions would have been helpful. BTW unlike me, flip the power off. I got a good shock from the accuator.

All work was done by hand. I removed the cover plate, unscrewed the existing water filter and screwed in the new one. I returned the cover plate to its original position and bled the air out of the line by running the water dispenser for a few minutes. It could no have been easier.

repair&parts instalation was easy but troubleshutting difficult.