Models > ARHC8700LL (P1142677NLL)

ARHC8700LL (P1142677NLL) Amana Range - Overview

Get Parts and Repair Help for ARHC8700LL

If you know the range repair part you need, you can browse the list of all parts on the ARHC8700LL, or you can search by name or part description. You can also find your part by where it is located on the ARHC8700LL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ARHC8700LL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$18.07

2 Piece Broiler Pan

$17.20

Terminal Block

It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

$57.89

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$26.62

Hinge Kit - Left Side

$36.89

Oven Light

$2.70

Screw

This screw is sold individually.

$95.45

Dual Radiant Element with Limiter

With the dual element you are able to adjust the size of the burner you want to use to match your pots/pans.

$27.77

Hinge Kit - Right Side

$38.95

Surface Infinite Switch

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Getting F 1 and 2 error codes and the oven turned itself off.

  • Customer: Suzanne from Acton MA
  • Difficulty: A Bit Difficult
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 44 of 87 people found this instruction helpful
Really easy but in this model there are 2 versions of the sensor, male and female. The website didn't have any place to see that. So the first sensor that came was male but we needed the other. After calling they sent me a return form and sent the new part (which was actually much cheaper) overnight and it went in very quickly. Would check this out again wh... read more

Outer Heater ring not working on dual burner.

  • Customer: Mark from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 14 of 16 people found this instruction helpful
Turned off power to unit.
Tilted up Glass top and removed two screws holding rear hinges to range. Then I unplugged wire harness from lower range and placed the Glass top facing down on counter top with towel for cushion. Removed 1 screw holding center of burner to support frame, two alignment screws on perimeter, and two screws holding support frame t... read more

Burned terminal block and filter board

  • Customer: Joseph from Decatur GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 31 of 69 people found this instruction helpful
Removed and replaced above named parts, rewired.Be sure to tighten all nuts that secure wires. I believe this is what caused the problem. read more