Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ARH6700LL (P1142637NLL)

ARH6700LL (P1142637NLL) Amana Range - Overview

Get Parts and Repair Help for ARH6700LL

If you know the range repair part you need, you can browse the list of all parts on the ARH6700LL, or you can search by name or part description. You can also find your part by where it is located on the ARH6700LL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ARH6700LL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

Order within the next 4 hrs and your part ships today!
$22.22

2 Piece Broiler Pan

The top of this part is now black.

Order within the next 4 hrs and your part ships today!
$33.42

Hinge Kit - Right Side

This hinge is located on the right side of the door.

Order within the next 4 hrs and your part ships today!
$4.89

SCREW

Order within the next 4 hrs and your part ships today!
$25.30

Leveling Leg

Sold Individually.

Order within the next 4 hrs and your part ships today!

Exterior Oven Door Glass - Black

This is just the outer glass and not the entire door assembly.

$5.50

Screw

Sold individually.

Order within the next 4 hrs and your part ships today!

SWTCH-LITE

KNOB- CLOC

Inner Door Glass

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Getting F 1 and 2 error codes and the oven turned itself off.

  • Customer: Suzanne from Acton, MA
  • Difficulty: A Bit Difficult
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 65 of 126 people found this instruction helpful
Really easy but in this model there are 2 versions of the sensor, male and female. The website didn't have any place to see that. So the first sensor that came was male but we needed the other. After calling they sent me a return form and sent the new part (which was actually much cheaper) overnight and it went in very quickly. Would check this out again wh... read more

Burned terminal block and filter board

  • Customer: Joseph from Decatur, GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 56 of 127 people found this instruction helpful
Removed and replaced above named parts, rewired.Be sure to tighten all nuts that secure wires. I believe this is what caused the problem. read more

Outer Heater ring not working on dual burner.

  • Customer: Mark from Richardson, TX
  • Difficulty: Really Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 21 of 23 people found this instruction helpful
Turned off power to unit.
Tilted up Glass top and removed two screws holding rear hinges to range. Then I unplugged wire harness from lower range and placed the Glass top facing down on counter top with towel for cushion. Removed 1 screw holding center of burner to support frame, two alignment screws on perimeter, and two screws holding support frame t... read more