Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ARG7800CC

ARG7800CC (P1143388NCC) Amana Range - Overview

Get Parts and Repair Help for ARG7800CC

If you know the range repair part you need, you can browse the list of all parts on the ARG7800CC, or you can search by name or part description. You can also find your part by where it is located on the ARG7800CC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ARG7800CC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$46.04

Flat Style Oven Igniter

You must reuse the original bracket. Be very careful to not touch the black element part of this igniter as it is very fragile.

$21.46

2 Piece Broiler Pan

The top of this part is now black.

$7.27

Bumper Pad Set of 4

***NOTE: This part has been substituted by the manufacturer and may not appear the same as the original but should function the same. These pads go on the bottom of your gas cook...

$56.78

Spark Ignition Module with Bracket

This part comes with the mounting bracket.

$33.42

Hinge Kit - Right Side

This hinge is located on the right side of the door.

$33.17

Hinge Kit - Left Side

$4.63

Drawer Wheel

Also known as a roller.

$4.94

SCREW

Dual Oven Safety Valve

***Please note: Before replacing the valve, you may want to check for a weak igniter. In most cases, the igniter should be replaced before you replace the valve.

$57.22

Door Gasket

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn't heat. Glow ignitor was weak and wouldn't ignite flame.

  • Customer: John from Niles, MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 57 of 61 people found this instruction helpful
After shutting off the gas and removing the oven door, which simply slid off of the hinges, I removed the oven plate. The ignitor was attached to the manifold. I removed that and noted the wires were attached back behind a hole in the back of the oven. I thought I would have to access them from the back but when I pulled on them I was able to reach them ... read more

Oven not working but broiler was working fine.

  • Customer: mark from macomb, MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 53 of 64 people found this instruction helpful
Checked lower oven burner for a problem. Oven Ignitor looked like it was glowing and working properly but the gas valve would not open to let the gas flow to burner. I had read on a forum that just because the oven ignitor looks good does not mean it is creating the proper resistance to open the gas valve. So I took my chances and replaced the ignitor (becau... read more

Broken Electrode, no spark

  • Customer: HUY from ALISO VIEJO, CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 39 of 47 people found this instruction helpful
Remove 2 screws holding the top burner. Remove 1 screw holding the electrode. Remove electrode from wiring using plier. Install new electrode and top burner read more