Models > ARG3601W Maytag

ARG3601W (P1143357N W) Amana Range - Overview

Get Parts and Repair Help for ARG3601W

If you know the range repair part you need, you can browse the list of all parts on the ARG3601W, or you can search by name or part description. You can also find your part by where it is located on the ARG3601W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ARG3601W parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$3.96

Single Door Strike

Sold Individually.

$15.20

Spark Ignition Electrode

Sold Individually.

$18.07

2 Piece Broiler Pan

$23.70

Oven Rack

$4.46

Base Door Latch

$2.70

Screw

This screw is sold individually.

$3.83

BRACKET

$27.77

Hinge Kit - Right Side

$4.46

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken Electrode, no spark

  • Customer: HUY from ALISO VIEJO CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 30 of 37 people found this instruction helpful
Remove 2 screws holding the top burner. Remove 1 screw holding the electrode. Remove electrode from wiring using plier. Install new electrode and top burner read more

Plastic clips had broken, causing bottom skirt piece to fall off.

  • Customer: William from Greensboro NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 13 of 14 people found this instruction helpful
After attempting to order this part from Whirlpool twice and twice receiving the wrong thing, found correct part on PartSelect in about one minute. Shipment came fast and the repair was very simple, under five minutes. You just pop the pieces in place and snap the piece back onto the oven. read more

Burner would not ignite when control in "light" position

  • Customer: Michael from Friendswood TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 11 of 12 people found this instruction helpful
Remove the two screws from the burner assembly (on top of the burner). Lift burner assembly from the cook top. Disconnect the electrode wire from the electrode. Remove the screw holding the electrode to the burner assembly (on bottom of burner). Install the new electrode and attach the electrode to the burner assembly. Attach the electrode wire to the el... read more