Models > AR141W

AR141W Jenn-Air Cooktop - Overview

Get Parts and Repair Help for AR141W

If you know the cooktop repair part you need, you can browse the list of all parts on the AR141W, or you can search by name or part description. You can also find your part by where it is located on the AR141W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Exact Part matches for your search term [Viewing 1 of 1]



This part number matches the current model number "AR141W".

Sections of the AR141W [Viewing 1 of 1]


Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.


Burner Cartridge Terminal Block

No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.




Radiant Surface Element with Limiter - 6" - 1200W


Terminal Block Insulator

This part fits inside your range's terminal block to act as an insulator for the contact spade.




Radiant Element - 8" - 2000W



This screw is sold individually. Size: 8-32 x 1/4 inch.




Radiant Cartridge Glass Top - White Model

This glass is gray speckled and used with white models.

Common Symptoms of the AR141W [Viewing 1 of 181]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

6" burner on the radiant surface started smoking and burned out.

  • Customer: Johnny from Henderson NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 15 of 22 people found this instruction helpful
Remove plug in unit from stove top. Turn over and remove the 7 screws from the 4 sides only. Turn back over holding unit together manually. Remove the glass top gently and lay it aside. Remove two wires that are plugged into the old unit, remembering which belongs where. You might want to remove one at a time and connect to new unit. Place new unit in ... read more

The top would not heat,large or small eye.

  • Customer: Calvin from Merced CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 12 of 19 people found this instruction helpful
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder. read more

Element had burnt out....break in actual element

  • Customer: Garth from Cypress TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Wrench set
  • 7 of 9 people found this instruction helpful
I first removed the plug in module on the left hand side. I then removed the six screws holding the tempered glass in place. Lifting straight up it then exposed the two elements. I unplugged the two wires connecting the large broken element and lifted up gently thus enablying the two loosely mounted screws to come out of their mounting bracket. I took those... read more