Models > AR140W

AR140W Jenn-Air - Overview

Get Parts and Repair Help for AR140W

If you know the repair part you need, you can browse the list of all parts on the AR140W, or you can search by name or part description. You can also find your part by where it is located on the AR140W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the AR140W [Viewing 1 of 1]

$3.76

Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

$87.85

Radiant Surface Element with Limiter - 8"

$4.46

SCREW

$23.12

Burner Cartridge Terminal Block

No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.

$4.60

Terminal Block Insulator

This part fits inside your range's terminal block to act as an insulator for the contact spade.

$3.82

Screw

This screw is sold individually. Size: 8-32 x 1/4 inch.

$25.99

Rivet

Use of this rivet requires a rivet tool.

$4.60

SCREW

$3.82

BRACKET

GLASS FRAME ASSY(RADI

Common Symptoms of the AR140W [Viewing 1 of 249]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The top would not heat,large or small eye.

  • Customer: Calvin from Merced CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 12 of 19 people found this instruction helpful
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder. read more

large element failed

  • Customer: Charles from Mamaroneck NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 9 of 19 people found this instruction helpful
Easy removal (lift and pull) of the the two element unit from the Jenn-air stove top. Placed unit right side up on a work surface. used a nut driver to remove 12 screws from the unit. removed the glass cook-top, revealing the two elements. Un-hooked two wires off the old damaged element, placed wires (plug and play) onto the new unit, then replaced the glas... read more

one side of cooktop did not work

  • Customer: Rebecca from Broadway NC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 4 of 5 people found this instruction helpful
I took out the side of the cooktop that did not work. I had to take off the bottom of the cooktop and checked where electricity was going and not going. Once I found the part that needed replacing, I went on the website, search for Jen-Air cooktops and model number. From the sketch on the website, I was able to order the part needed. I decided to get 2 in or... read more