Models > AOGD2750WW (P1132527NWW)

AOGD2750WW (P1132527NWW) Amana Oven - Overview

Get Parts and Repair Help for AOGD2750WW

If you know the oven repair part you need, you can browse the list of all parts on the AOGD2750WW, or you can search by name or part description. You can also find your part by where it is located on the AOGD2750WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for AOGD2750WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$18.07

2 Piece Broiler Pan

$2.70

Screw

This screw is sold individually.

$57.89

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$36.73

Flat-Style Oven Igniter - Bake/Broil

This igniter doesn't come with the bracket or the connector. It can be used for either the bake or broil in your appliance.

$36.89

Oven Light

$2.70

Frame Screw

Sold Individually.

$184.20

Electronic Control Board

This electronic board is located within the control panel.

$31.58

Door Hinge - Left Side

RACK, OVEN 19 3/16 X 16 1/2

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Getting F 1 and 2 error codes and the oven turned itself off.

  • Customer: Suzanne from Acton MA
  • Difficulty: A Bit Difficult
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 43 of 84 people found this instruction helpful
Really easy but in this model there are 2 versions of the sensor, male and female. The website didn't have any place to see that. So the first sensor that came was male but we needed the other. After calling they sent me a return form and sent the new part (which was actually much cheaper) overnight and it went in very quickly. Would check this out again wh... read more

STOVE WORK BUT YOUR OVEN WON'T GET HOT ?

  • Customer: Brian from Cumming GA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
IF YOUR STOVE WORK'S BUT YOUR OVEN WON'T GET HOT IT IS YOUR IGNIGTER THE IGNIGHTER IN PROPER WORKING CONDITION SENDS A SIGNAL TO THE GAS VALVE SAYING LET THE GAS FLOW ITS OK. WHEN THE IGNIGHTER QUITS WORKING IT WON'T LET THE GAS FLOW AND YOUR OVEN WILL NOT GET HOT. IT IS AN EASY FIX. JUST PULL OUT ALL OF INTERIOR PARTS THE RACKS AND THE BOTTOM HEAT SHIELD TH... read more

oven would not light

  • Customer: MATTHEW from SAN CLEMENTE CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
Removed oven door and burner guard. Removed screws holding ignitor bracket and small panel beneath oven door. Disconnected ignitor wires behind panel and pulled out ignitor. Removed old ignitor from bracket and inserted new unit. Fed wires back down thru tubing and screwed in bracket. Connected wires and replaced panel. (Note: old ignitor glowed but would no... read more