Models > ALZ8580ADB

ALZ8580ADB Amana Cooktop - Overview

Get Parts and Repair Help for ALZ8580ADB

If you know the cooktop repair part you need, you can browse the list of all parts on the ALZ8580ADB, or you can search by name or part description. You can also find your part by where it is located on the ALZ8580ADB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for ALZ8580ADB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ALZ8580ADB [Viewing 2 of 2]

$3.81

Rubber Grommet

Used as the bottom feet of a gas stovetop grate. Sold individually.

$15.25

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$15.74

Ignition Knob

This small black knob is used to turn on the igniter.

$4.60

Bushing

Sold individually.

$36.16

Burner Head Cap with Spark Electrode

This part distributes flame evenly to your cookware.

$99.00

Regulator Kit with Fitting

This part will cut off the flow of gas to your appliance once it reaches a certain pressure.

$3.83

SCREW

$16.98

Burner Knob

Sold individually.

KNOB- VALV

$48.23

USE WPL 74003946

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burner ignitor failure

  • Customer: roy from East Providence RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 61 of 68 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more

The grommets came apart metal from rubber.

  • Customer: Frank from Pierce ID
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 11 of 14 people found this instruction helpful
I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price. read more

burner would not light; ignitor did not produce spark

  • Customer: Candace L. from Woodinville WA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 10 people found this instruction helpful
Take a few screws off the back of the slide in burner module. Take off the back. Unscrew the ignitor screw, remove ignitor carefully, replace with the new ignitor, put the screw back in, put the back back on, try it out! Ours worked after a couple of tries - don't know if the ignitor had to "rev up" by several sparks or we just didn't have it properly ins... read more