Models > ALY2280BDB

ALY2280BDB Amana Range - Overview

Get Parts and Repair Help for ALY2280BDB

If you know the range repair part you need, you can browse the list of all parts on the ALY2280BDB, or you can search by name or part description. You can also find your part by where it is located on the ALY2280BDB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ALY2280BDB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ALY2280BDB [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.78

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$3.81

Rubber Grommet

Used as the bottom feet of a gas stovetop grate. Sold individually.

$2.70

Screw

This screw is sold individually.

$12.82

Ignition Knob

This small black knob is used to turn on the igniter.

$2.77

Screw - sold individually

$4.60

Bushing

Sold individually.

$4.60

SCREW

$36.43

Oven Rack

Sold individually.

$27.01

USE WPL 74010544

$35.89

Door Handle - Black

Handle spacers and screws are sold separately.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burner ignitor failure

  • Customer: roy from East Providence RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 52 of 59 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more

The grommets came apart metal from rubber.

  • Customer: Frank from Pierce ID
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 10 of 13 people found this instruction helpful
I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price. read more

burner would not light; ignitor did not produce spark

  • Customer: Candace L. from Woodinville WA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 10 people found this instruction helpful
Take a few screws off the back of the slide in burner module. Take off the back. Unscrew the ignitor screw, remove ignitor carefully, replace with the new ignitor, put the screw back in, put the back back on, try it out! Ours worked after a couple of tries - don't know if the ignitor had to "rev up" by several sparks or we just didn't have it properly ins... read more