Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ALG331RAC (PALG331RAC1)

ALG331RAC (PALG331RAC1) Amana Dryer - Overview

Get Parts and Repair Help for ALG331RAC

If you know the dryer repair part you need, you can browse the list of all parts on the ALG331RAC, or you can search by name or part description. You can also find your part by where it is located on the ALG331RAC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for ALG331RAC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$20.00

Multi Rib Belt - 93-3/8"

At 93-3/8" inches in length, this dryer drum belt from Amana has five ridges. It is all black in color and is made entirely of rubber. A flat belt, it is 3/8 of an inch wide.

Order within the next 3 hrs and your part ships today!
$9.41

Drum Support Roller - for square ported models

This single drum support roller is used for square ported model clothes dryers. It has a metallic bearing in its center.

Order within the next 3 hrs and your part ships today!
$27.70

Radiant Flame Sensor

This part senses the flame for heat allowing the gas valve to open.This flame sensor is three inches long and is used for many gas clothes dryers.This flame sensor assembly is made...

Order within the next 3 hrs and your part ships today!
$33.58

Lint Filter

Note: This part no longer comes with the felt seal. This filter collects lint as it passes through the dryer vent.

Order within the next 3 hrs and your part ships today!
$8.55

Idler Pulley Wheel with Bearing

This two inch wide idler pulley wheel is beige in color and is made of plastic. This pulley wheel comes with its own metallic bearing in its center.

Order within the next 3 hrs and your part ships today!
$5.15

Washer, Thrust

This washer is 3/4 inches in diameter.

Order within the next 3 hrs and your part ships today!
$15.35

Door Catch Kit

This kit comes in two pieces: the catch and the clip.

Order within the next 3 hrs and your part ships today!
$17.35

Door Switch Kit

This part replaces older two terminal switches.

Order within the next 3 hrs and your part ships today!
$18.45

Cylinder Felt Seal

This part is located between the back of the drum and the rear dryer panel.

Order within the next 3 hrs and your part ships today!
$22.51

Cylinder Glide Bracket

These brackets support each side of the tub. Order quantity needed.

Order within the next 3 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Drum not centered , clothes getting stuck in dryer

  • Customer: Chris from Hopedale, MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 492 of 500 people found this instruction helpful
The first thing I did was to unplug the dryer from the wall. Then I removed the bottom two screws and slid the bottom cover off so i could see all the way to the back, I tipped the dryer back against the wall and searched for the problem with a flashlight. I noticed that one of the guide wheels that held the drum in place was sheared off. I took the new d... read more

The Felt Gasket between drum and door ripped, vent manifold from Dryer to fan and lint screen broken

  • Customer: Tim from South Glens Falls, NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 482 of 485 people found this instruction helpful
I pulled the bottom panel and the door panel to replace the manifold and felt gasket around the drum. I removed old gasket very easily, it peeled right off. I use brake cleaning fluid (Spray Can from Auto Zone about $1.45) to remove old glue. Used spray contact cement (Elmer's about 4.50 at Ace) and sprayed the panel and gasket surfaces and let dry. I th... read more

Filter Lint Was Broken

  • Customer: Mirsada from Yorktown Heights, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 372 of 374 people found this instruction helpful
Took it out of the box and put it in the dryer. I could not find this part anywhere else but on this website. The item was delivered the next day to my surprise. read more