Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Amana Dryer ALE331RAW - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.
This 1/4 horsepower gas or electric clothes dryer motor carries 120 volts, 60 Hz, and 5.5 amps. It also performs 1725 revolutions per minute. This motor is used for some gas and some electric clothes dryers.
The metal retaining ring, which is under an inch long, holds the rear wheels on the axels of the dryer. The main reason why it would need to replaced is if the retaining ring has s...
If your dryer is noisy, will not tumble, or is not producing enough heat, you may need to replace the blower wheel. This part is white in color, and is made of plastic. This part is approximately 8 inches in diameter. The blower wheel is located near the bottom of your dryer cabinet. To access it for this repair, you will need to remove both the front panel and the front bulkhead assembly. Before you begin this repair, be sure to disconnect the power source to the dryer. To complete this repair, you will need a 5/16 inch nut driver, a 1/4 inch nut driver, a pair of locking pliers and a 7/8 socket with a short extension and a ratchet.
This part includes the upper and lower air duct assembly and lint screen.
This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than usual during the wash cycle, your spring retaining clip could be faulty or damaged. Check the clip for visible damage, wear, and rust. If you notice any signs of damage, the part should be replaced. Remember to disconnect the power from your washing machine before starting this repair.
This arm is what attaches to the idler pulley wheel.
This cycling thermostat has a limit of 153 degrees Fahrenheit, meaning that your dryer will cut out when the internal temperature reaches 153 degrees. It kicks back in though, when the temperature drops by 15 degrees Fahrenheit. This thermostat is just about two inches long.
This thermostat heater is two inches long. It is beige/brown in color and is made of plastic.
This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.
This screw is sold individually.
This pad is used for many clothes dryers. It is made of a felt material and it is a little over an inch long.
This clamp is used to secure the drive motor.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.