Models > AKS30WW

AKS30WW (P1142501N W) Amana Cooktop - Overview

Get Parts and Repair Help for AKS30WW

If you know the cooktop repair part you need, you can browse the list of all parts on the AKS30WW, or you can search by name or part description. You can also find your part by where it is located on the AKS30WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

SCREW

$73.46

Spark Ignition Module with Bracket

$2.70

Nut

Electrode Retaining Clip

This clip is well under an inch in diameter. It is made of metal and it will help secure a range's electrode.

$39.30

Gas Spark Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

Small Burner Cap

Large Burner Cap

This large white burner cap is four inches in diameter.

Ignition Wire Harness - 20"

$21.48

HARNESS- I

KNOB, TOP CONT (WHITE)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

2 of 4 burners wouldn't light

  • Customer: John from Alexandria VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 15 of 17 people found this instruction helpful
Unplugged the stove, removed all 4 burner discs from the stove top (2 screws each) and disconnecting electrode wires as I pulled them out, removed the stove top, unscrewed the old module, removed the 6 wires, connected wires to the new module, screwed it into place, reinstalled the top while poking the electrode wires through the top one by one, put the sto... read more

Spark did not ignite one burner and sometimes two

  • Customer: Frederick from Eagle WI
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 10 of 12 people found this instruction helpful
I could not figure out how to get to the igniter until I went to the "Part Select" web site and found a post that was exactly like the problem that I had. IE: Remove two screws holding each burner, Lift off top, remove old igniter being "Carefull" not to mix up the wires when putting them on the new one, installed new igniter in bracket and mounted in positi... read more

pre- igniter went bad. No spark

  • Customer: Edward from Schaghticoke NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 7 of 12 people found this instruction helpful
The trick with any appliance is to remove all the extras,before you get to the problem.Considering that it has electricity, the first step was to turn it off.
After that it was a matter of removing the top burners,range knobs and locate the panel screws that secure it to the stove.Locate the part,remember the colors of where the wires go,remove,replace ... read more