Models > AKS3040BCC

AKS3040BCC Amana Cooktop - Overview

Get Parts and Repair Help for AKS3040BCC

If you know the cooktop repair part you need, you can browse the list of all parts on the AKS3040BCC, or you can search by name or part description. You can also find your part by where it is located on the AKS3040BCC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.76

Grate Foot

Sold individually.

$2.70

Screw

Sold individually.

$14.50

Surface Burner Spark Igniter

This part helps your burner ignite and produce flame.

$2.70

Screw

This screw is sold individually.

$3.96

Grommet

$78.54

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$45.20

Igniter Switch Assembly

This assembly contains 4 ignition switches and the wire harness.

$24.96

BURNR-HEAD

$2.70

Screw

This screw is sold individually.

$19.83

BURNR-HEAD

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

top burners on stove won't ignite ,no clicking noise

  • Customer: scott from centreville VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 26 of 40 people found this instruction helpful
remove small panel on right side of stove,then un clip moduke and put wires from old module to new one.
Exact fit nomproblems. read more

spark igniter was weak and not lighting the flame.

  • Customer: Daniel from Needham MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set, Wrench(Adjustable)
  • 18 of 22 people found this instruction helpful
Open top oven door and remove the 2 front screws which hold the burners and controls to the frame. DO NOT lift the burners more than an inch or so to look inside. You WILL bend the gas lines in the back if you do. Pull out stove from the wall, shut off gas supply and disconnect hose if needed to have room to work. Remove top back panel and remove the 3 wires... read more

Ignitor on main burner would not create a spark

  • Customer: Michael from Bloomington IL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 16 of 24 people found this instruction helpful
Having no manual nor finding any instructions online, I spent a while trying to figure out how to safely get to the ignitor mounting screw under the range top. I popped the snap clips on either side of the stove to loosen the top and pulled the top up a few inches to see why it was being difficult to raise. It turns out that the gas piping was solidly attach... read more