Models > AKG30E (P1172201S)

AKG30E (P1172201S) Amana Cooktop - Overview

Get Parts and Repair Help for AKG30E

If you know the cooktop repair part you need, you can browse the list of all parts on the AKG30E, or you can search by name or part description. You can also find your part by where it is located on the AKG30E by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the AKG30E [Viewing 2 of 2]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$20.14

Top Burner Spark Ignition Electrode with Retaining Clip

This part helps your burner ignite and produce flame.

$5.17

SCREW

This screw is sold individually.

$114.82

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$5.17

Screw

Sold individually.

CAP, BURNER (LARGE)

Ignition Valve Switch

CAP, BURNER (SMALL)

$2.88

GROMMET- C

$5.74

SCREW

$5.74

NUT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burners kept clicking after ignited

  • Customer: Robert from Ranchos de Taos NM
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 21 of 31 people found this instruction helpful
After I bought this part, installed it and the clicking still did not stop I finally found the problem. If your ignitor can still click then it's still good. The problem is the electric connection between the head burners and the base burners (Top Assembly diagram). Put a little weight on the head burner while grabbing it with your hand and grind it into the... read more

There was a crack in the porcelain not letting it spark

  • Customer: Billy from Martinsville IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 17 of 24 people found this instruction helpful
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire.
Then just connected the new electrode and place the assy, in the burner. read more

broken ignitor insulation; repeated sparking after burner lit

  • Customer: Joe from San Bruno CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 8 of 13 people found this instruction helpful
Disconnected gas & electric connections; lifted unit out of countertop onto padded table upside down. Unscrewed ~16 sheet metal screws for access. Removed bad ignitor by driving off retaining clip. Had to remove burner (3 screws) for access to install retaining clip on new ignitor. Reassembled, reinstalled. Works like new! read more