Models > AKDG2WW (P1131623N W)

AKDG2WW (P1131623N W) Amana Cooktop - Overview

Get Parts and Repair Help for AKDG2WW

If you know the cooktop repair part you need, you can browse the list of all parts on the AKDG2WW, or you can search by name or part description. You can also find your part by where it is located on the AKDG2WW by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the AKDG2WW [Viewing 4 of 4]

$3.82

SCREW

$39.95

Surface Burners Spark Module Kit

$3.82

Nut

Filter Assembly

This filter assembly is just under eleven inches long and is not quite six inches wide. It is a metallic filter and it is used with some downdraft ranges.

KNOB, TOP CONT (WHITE)

SHIELD, SWITCH

VALVE, SURFACE BURNER

SELECTOR SWITCH

SWITCH, MODULE

MOTOR, FAN 115V 60HZ

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burners and gas oven would not light

  • Customer: nicholas from livermore CA
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
unplug the oven and pull it away from the wall. looking at the oven from the back, the spark module is at the bottom on the lower left. there is a two piece sheetmetal cover over the area of the spark module. use a phillips head screwdriver to remove five screws and the covers come off. the spark module is the blue cube with four push on wire connectors.... read more

The range burners would not catch a spark and ignite. They would just keep clicking with no ignition.

  • Customer: Adrienne from Lake Havasu City AZ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 3 of 3 people found this instruction helpful
I had an appliance repair rep do the replacement. He made it look relatively easy.
The repair man first turned off the breaker to the range and confirmed there was no power to the range.
After lifting off the range top cover exposing the burner igniters, he unhooked and removed the igniters. He opened the lower oven door exposing the screws whi... read more

Igniters did not spark

  • Customer: Steve from Sedona AZ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 2 of 2 people found this instruction helpful
Unplug and pull range away from wall.
Remove metal panel from back of range by using nutdriver to remove 4 screws.
Use phillips scewdriver to remove 2 screws holding old spark module.
Unplug 4 wires from spark module and note placement of wires for reinstall.
Install new module by reversing procedure.
Slide range back against wall an... read more