Models > AK2H35HR (P1171804S)

AK2H35HR (P1171804S) Amana Cooktop - Overview

Get Parts and Repair Help for AK2H35HR

If you know the cooktop repair part you need, you can browse the list of all parts on the AK2H35HR, or you can search by name or part description. You can also find your part by where it is located on the AK2H35HR by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the AK2H35HR [Viewing 2 of 2]

$61.68

Surface Ribbon Element with Limiter - Small

This is a 1500 watt surface element.

Control Hole Cover

This control hole cover sits under the control knob.

$24.70

Screw

$105.05

Dual Radiant Burner Element with Limiter

$46.55

Surface Control

This switch controls the stove top surface burner.

$19.80

Control Knob

Sold Individually.

$2.70

Screw

This screw is sold individually. Size: 8-32 x 1/4 inch.

Control Knob

Sold Individually. This knob accepts a double-flat shaft.

Surface Burner Control Switch

This dual surface burner infinite control switch is just under three inches long. Using 240 volts, this switch will operate at 15 amps.

$3.83

SCREW

Common Symptoms of the AK2H35HR [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Element not heating

  • Customer: Richard from Weatherford TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers
  • 4 of 5 people found this instruction helpful
This was a countertop mounted cooktop. The hardest part of the repair was getting the cooktop out of the hole and separating the glass top from the burner box. It is highly recomended that you have two people to seperate the top from the burner box. Be sure you turn off the breaker to the cooktop first before you do any work. One time saver is once you have ... read more

Replacement of burner control switch

  • Customer: Farouk from Sudbury MA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 3 of 4 people found this instruction helpful
1. Open the circuit breaker feeding the range. Turn all range control switches ON to establish that there is no power. Remove all knobs.
2. Get under the range and remove the 2 hex-head screws securing the flex conduit to the bottom panel. Then remove the 20 hex-head screws securing the panel to the range. Lower the panel and place aside, and then after... read more

2 controls were damaged and not working correctly. One would not properly shut off.

  • Customer: Edward from Sunnyvale CA
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 2 of 3 people found this instruction helpful
1. Turned off the 240V branch circuit to the cooktop.
2. Removed and inverted the cooktop.
3. Removed the bottom panel, used 1/4-inch nut driver to remove the sheet metal screws.
4. Confirmed the circuit was de-energized. Voltmeter set to AC, measure across the L1, L2 connections, should be 0 VAC or very close.
5. Make a diagram of the ex... read more