Models > AGR4412ADW

AGR4412ADW Amana Range - Overview

Get Parts and Repair Help for AGR4412ADW

If you know the range repair part you need, you can browse the list of all parts on the AGR4412ADW, or you can search by name or part description. You can also find your part by where it is located on the AGR4412ADW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for AGR4412ADW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$15.25

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$55.77

Gas Oven Igniter - Vertical Mount

This gas oven igniter is a little over three inches long. It has a white ceramic base and a gray silicon carbide igniter. This igniter assembly comes with its own metallic mounting...

$3.76

Levelling Leg

This leg is sold individually.

$27.32

Burner Head Cap with Spark Electrode

This part has been redesigned and no longer requires a gasket seal.

$23.66

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$30.71

Door Seal

This oven door seal prevents heat from escaping the oven cavity when in use. It contains all of the attaching clips needed for installation.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn’t heat up properly

  • Customer: James from Berwick ME
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 125 of 137 people found this instruction helpful
My oven has two igniters so I needed to determine which one was the problem.

Using the amp/multi meter I tested the connection between the igniters and the valve, with the oven turned on, to find the bad igniter. Depending on the model of stove you have, the amp reading you need for a properly functioning igniter will vary. My lower igniter read ... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 70 of 78 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more

gas burner ignitor failure

  • Customer: roy from East Providence RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 62 of 71 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more