Quick Question!

Have you ever purchased from PartSelect.com before?

Models > AGR4412ADB

AGR4412ADB Amana Range - Overview

Get Parts and Repair Help for AGR4412ADB

If you know the range repair part you need, you can browse the list of all parts on the AGR4412ADB, or you can search by name or part description. You can also find your part by where it is located on the AGR4412ADB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for AGR4412ADB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$16.57

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$50.37

Oven Igniter - Vertical Mount

This broil igniter assembly comes with its own metallic mounting bracket and an seven inch long dual wire lead with a plastic plug.

$23.99

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$66.33

Inner Door Glass Pane

Glass only.

$100.06

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$5.15

Insulation

This strip of insulation is located within the oven door.

$4.89

USE WPL 74004558

$8.01

Handle Bracket - Right Side

$8.01

Handle Bracket - Left Side

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn’t heat up properly

  • Customer: James from Berwick, ME
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 193 of 216 people found this instruction helpful
My oven has two igniters so I needed to determine which one was the problem.

Using the amp/multi meter I tested the connection between the igniters and the valve, with the oven turned on, to find the bad igniter. Depending on the model of stove you have, the amp reading you need for a properly functioning igniter will vary. My lower igniter read ... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham, AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 120 of 129 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more

gas burner ignitor failure

  • Customer: roy from East Providence, RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 102 of 115 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more