Models > AGM584E

AGM584E (P1143518N E) Amana Range - Overview

Get Parts and Repair Help for AGM584E

If you know the range repair part you need, you can browse the list of all parts on the AGM584E, or you can search by name or part description. You can also find your part by where it is located on the AGM584E by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for AGM584E parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$18.07

2 Piece Broiler Pan

$16.02

Top Burner Spark Ignition Electrode with Retaining Clip

$2.70

Screw

This screw is sold individually.

$3.82

Frame Screw

Sold Individually.

$136.17

MODULE- SP

$4.46

Drawer Glide

Sold individually. This part helps your drawer glide in and out smoothly.

$3.82

Nut

$16.29

Leveling Leg

Electrode Retaining Clip

This clip is well under an inch in diameter. It is made of metal and it will help secure a range's electrode.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

There was a crack in the porcelain not letting it spark

  • Customer: Billy from Martinsville IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 16 of 21 people found this instruction helpful
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire.
Then just connected the new electrode and place the assy, in the burner. read more

The Ignitor? would not spark to light the burner.

  • Customer: Janie from Montrose CO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 7 of 11 people found this instruction helpful
First I unplugged the electric line to the range. Then I removed the screw that holds the burner in place and then lifted the burner up. Pulled the elec line off it and then took the ignitor/sparker? out of the burner. inserted the new one and put the elec wire to it. screwed it back in place and turned on elec and tried the burner. But now it sparks som... read more

broken ignitor insulation; repeated sparking after burner lit

  • Customer: Joe from San Bruno CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 6 of 11 people found this instruction helpful
Disconnected gas & electric connections; lifted unit out of countertop onto padded table upside down. Unscrewed ~16 sheet metal screws for access. Removed bad ignitor by driving off retaining clip. Had to remove burner (3 screws) for access to install retaining clip on new ignitor. Reassembled, reinstalled. Works like new! read more