Models > AGM409L2 (PAGM409L2) > Parts

AGM409L2 (PAGM409L2) Amana Dryer - Parts

All parts for the Amana Dryer AGM409L2

Below is a list of all parts for the Amana Dryer AGM409L2 - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the AGM409L2
1-14 of 191
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

'M' Series New Style Coil Kit

This gas dryer ignition coil set comes with two ignition coils: one three terminal Boost/Hold coil, and one two terminal secondary coil. Usually only one of them burns out but you ...


Multi-Rib Belt

At 93-3/8" in length, this flat dryer drum belt has 5 ridges and is 3/8" wide.


Drum Support Roller

This roller is for square-ported models and has a metallic bearing in its center. They are sold individually and most dryers use 2 rollers at the rear and it is recommended to repl...


Drum Glide

This drum glide is sold individually. ***Please Note: these should be replaced in pairs.


Idler Pulley Wheel with Bearing

A dryer's idler pulley wheel serves to help the belt to rotate the drum.


High Limit Thermal Fuse

Meant as a backup to a high limit thermostat, this fuse is typically set to trip at a higher temperature than that of a high limit thermostat. This is a one-time use fuse, so when it does trip, you do need to replace it. It's letting you know that something is wrong with your dryer.


Radiant Flame Sensor

This part senses the flame for heat allowing the gas valve to open.


Idler Lever

The spring for this part is sold separately.


Thrust Washer

This washer is 3/4 inches in diameter.


Door Catch Kit

This kit comes in two pieces: the catch and the clip.


Cylinder Felt Seal

This part is located between the back of the drum and the rear dryer panel.


Door Switch Kit

This part replaces older two terminal switches.


Retaining Ring

Sold individually.


Limit Thermostat

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 225 degrees Fahrenheit. The element will kick back in when the temperature drops to 185 degrees Fahrenheit - the differential of 40 degrees.

All Parts for the AGM409L2
1-14 of 191