Models > AG200B

AG200B Jenn-Air Refrigerator - Overview

Get Parts and Repair Help for AG200B

If you know the refrigerator repair part you need, you can browse the list of all parts on the AG200B, or you can search by name or part description. You can also find your part by where it is located on the AG200B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Exact Part matches for your search term [Viewing 1 of 1]

$230.43

MODULE

This part number matches the current model number "AG200B".

Sections of the AG200B [Viewing 1 of 1]

$2.70

Screw

This screw is sold individually.

$88.70

Double Burner Pan - Black

This pan sits under the burner to catch anything that may spill over to make cleaning up easy. Also known as Aeration Pan. Sold individually.

$42.73

USE WPL 74005001

$45.95

Rear Burner

This black burner head has a glossy finish.

$45.46

Single Burner Grate

$43.61

Burner Bracket - Black

This bracket supports the front and rear burner assembly.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Front burner inoperative

  • Customer: Robert from Portland OR
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 2 of 3 people found this instruction helpful
Simply removed the front burner using 1/4 incn nutdriver on
two screws.placed new burner in position and tightenwd two screws.
Simplest and easiest job I ever did!
Works as new! read more

20 year old burners were slow to light and hard to adjust for our propane fired stove. And, they were scratched and ugly

  • Customer: thomas from Goodrich TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 2 of 3 people found this instruction helpful
Removed four screws; withdrew two burners; set two new burners in place; installed same old screws. That was it. When I turned them on to adjust the flame, they came on almost instantly and no adjustment was needed.

Wife loves the nice new look. read more

Burner Ports were worn and oversize

  • Customer: John H from Newfoundland PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 2 of 3 people found this instruction helpful
Removed the two screws that hold burners on mounting bracket . Removed burners and installed new burners. re-adjusted air flow to elimenate yellow flame. read more