AFI2538AES00 Whirlpool Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
I shut the door while tray was open,broke pin on tray
took screws out put new end cap on put pack screws and was done. just that easy. Thank you
Parts Used:
-
Loren from E Wenatchee, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Replaced ice & Water filter, but message on refigerator still shows "Replace Filter"
-
David from Portland, OR
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
The Door Tab Broke Off
Pull drawer x2 pull glass shelf pull glass shelf support pull deli drawer cover then drawer pull left drawer guide screws 2 pull glide screws 2 reassemble clean as you reverse process easy
Parts Used:
-
Jeffrey from Kirkland, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Light switch broken
I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!
Parts Used:
-
Keith from Racine, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
broke the tray door hinge.
removed the drawers and shelf. removed end cap with a socket replaced new part, reinstalled drawers and shelf. probably took 7 minutes start to finish.
Parts Used:
-
richard from margate, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
Was this instruction helpful to you?
Thank you for voting!
broken center rail
The only challenge is: finding the correct replacement part for this model. Once that is done, the part just slides in, no tools needed.
Parts Used:
-
Elisabeth from Reston, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Broken Pantry Lid Cover Hinge
It was easy, since I took the old one out, I knew what to do to put the new one in. Not problem, just a couple of screws!
Parts Used:
-
David from San Jose, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench set
Was this instruction helpful to you?
Thank you for voting!
Frig & freezer section would not cool/too warm
Easy to replace part - remove panel at the bottom rear of the appliance, unplug from the compressor and connect the new relay. Unfortunately, it was not the relay on my appliance -- looks like the compressor has gone out -- new fridge for me
Parts Used:
-
Alan from Trafalgar, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Plastic clips broke
New kick plate snapped right into place. Did not need the grille clips
Parts Used:
-
Darryl from Santa Fe, NM
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
frige warm and freezer icing up
I pulled the frige out, took off the cover from the bottom with a nut driver. Took off the safety clip then pulled the plug out from the relay then the relay came out. Replaced the part and reinstalled the same way. This was really easy and fast.
Parts Used:
-
Tricia from Folsom, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
brokenpivot arm
-
Will from Missoula, MT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
broken viewer
-
Acte from New York, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Ice and Water Filter needed to be replaced.
I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.
Parts Used:
-
Louis from Covington, KY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
pins holding cover were broken off
My son in law was able to take off the defective end pieces, and replace them with the new ones, in about 20 minutes. 10 minutes were probably spent in finding the right tools.Very easy to do. Parts were received within 2 days of ordering (I placed order on a Sunday).I was able to find the parts right away on your inter net lay out.
Parts Used:
-
Patricia from San Mateo, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Unable To Control Temp. On Touch Pad
I first change the board behind the touch pad on front of ref. That controls switching from ice to water and temps. Problem ended up being the actual touch screen itself. Part select was great helping with parts and return first part and shipped touch screen out asap.
Parts Used:
-
Patrick from long beach, CA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!