Models > AEW4630DDQ

AEW4630DDQ Amana Oven - Overview

Get Parts and Repair Help for AEW4630DDQ

If you know the oven repair part you need, you can browse the list of all parts on the AEW4630DDQ, or you can search by name or part description. You can also find your part by where it is located on the AEW4630DDQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for AEW4630DDQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$28.12

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$36.18

Door Hinge

This hinge is located on each side of the oven door.

$2.70

Screw

This screw is sold individually.

$18.07

2 Piece Broiler Pan

$17.58

Terminal Block

It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

$23.87

Light Lens

$2.77

Screw - sold individually

$48.74

Bake Element

$3.84

NUT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 67 of 72 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 24 of 27 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

Oven door doesn't completely close, light stays on

  • Customer: John from Harvard MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 22 of 35 people found this instruction helpful
I replaced the hinges on the door, it wasn't that hard to do, a couple of minor things I had to overcome. But the new hinges still don't close the door completely. The light still comes on. I don't think the springs in the hinges are strong enough.

I asked for a particular part number in my order, the sales rep, said that wasn't the correct... read more