Models > AES3540BAW

AES3540BAW Amana Range - Overview

Get Parts and Repair Help for AES3540BAW

If you know the range repair part you need, you can browse the list of all parts on the AES3540BAW, or you can search by name or part description. You can also find your part by where it is located on the AES3540BAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for AES3540BAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$28.12

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$8.79

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$34.46

Drip Bowl Kit - Light Gray

This is a kit of 4 drip bowls - Two 6" and two 8". All pans have holes in the bottom and they are light gray in color.

$35.96

Element Infinite Switch - 8"

This is the left front element switch.

$44.14

Oven Rack

Used in the lower oven. Sold individually.

$32.77

Door Gasket

This oven door gasket comes with built in retaining clips.

$44.24

Bake Element

This bake element is found on the bottom of the oven.

$2.70

Screw with Washer

$52.11

Inner Door Glass Pane

Glass only.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 112 of 122 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 88 of 101 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

I needed drip bowls that fit properly

  • Customer: Marilyn from Peachtree City GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 36 of 20 people found this instruction helpful
I ordered gray enamel drip bowls and they fit perfectly. Unfortunately 2 of them were chipped and bent slightly. They still worked which was better than the make shift ill fitting ones that came with the house so I decided to keep them. I did tell parts select about it and they sent me a new order of drip pans at no charge. I used the perfect ones but th... read more