ADW662EAB (PADW662EAB0) Amana Dishwasher - Instructions

Replaced the inner door foam insulation strip and door gasket.I believe the "secret" is not to push the door gasket in all the way. Let the door find its own seat. Problem fixed.

This was as simple a repair as you will ever get, at least on a 16 year old Maytag like we have. Literally just take the old gasket out and put the new one in -- just make sure to look at the old gasket to ensure you are inserting the proper end of the new one into the channel, I almost put it in wrong, but then again I'm brain damaged where home repairs are concerned. The door is more difficult to close after I put the gasket in, so I may have to adjust the door closing mechanism just a tad.

Great instructions, great service. But I have not yet made the repair.

plastic form inside dishwasher does not press into foam insulation strip hard enough to stop water from leaking. It is still leaking

Installing the door gasket is relatively easy, it just pushes in place without any adhesive. Just make sure it is even on both sides
You can to pull it out and reinstall to even it all way around the door if needed.
You may also find a new gasket will make to door a little harder to close. I presume it will be easier to close over time.
I also installed a new float at the same time but that repair is very difficult, takes specialized tools and lots of patience.

Took apart per video on Part Select found broken piece. Ordered new part and replaced 4 days later.

replaced basket with a new one, so easy even a cave man could do it.....i think.......

look the instrution on line and it worked great.

I put the new one in and that was all

I twice watched the 5 minute video on PartSelect on how to repair the Discharge Pump Housing. I disassembled as instructed. One thing I did that the video did not suggest is that I marked the alignment of all parts with a pencil before removing any screws. In the end it only mattered on the main housing that covers the filter. That has to be put back on the way it came off. The repair is complete and for under $50 the dishwasher is running great and quieter than I can ever remember.

Just snapped in plastic retainer and works just fine now

No repair, just an replacement. Would recommend this company for good service.

removed the lower dish basket; used pliers to undo the lock screw. removed the lower spray arm, transfered heat shields from old part to new, replaced the lower spray arm, hand tightened the lock screw, replaced the lower dish basket....DONE!

Replacement part has only 6 wheels. The original part has 8 wheels. The lack of the two extra wheels allows the dish rack to get stuck in the space between the inside of the dishwasher and the door. The extra set of wheels allows the rack to bridge the gap. It is a problem even if you put the rack in the other way around only a bit worse to deal with. The part was designed with four sets of wheels for a reason.

I had a Dishwasher tech.. there to check out a leak in the door gasket....he was kind of enough to put then new panel on.. Was a snap.. Two screws.. and good as new. I assisted in the removal of the protective film.. Thank you, Vickie