Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ADW1100N10BB

ADW1100N10BB General Electric Dishwasher - Overview

Get Parts and Repair Help for ADW1100N10BB

If you know the dishwasher repair part you need, you can browse the list of all parts on the ADW1100N10BB, or you can search by name or part description. You can also find your part by where it is located on the ADW1100N10BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for ADW1100N10BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ADW1100N10BB

[Viewing 3 of 3]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$0.77

RACK SLIDE END CAP

The rack slide end cap is the part that attaches to the rails of your upper dish rack and prevents the dishrack from sliding too far. If you find the dish rack is causing the door ...

$21.74

Lower Rack Wheel Kit - 8 Pack

This lower rack wheel kit includes 8 wheels and 8 axles that allow the lower dishwasher rack to slide in and out smoothly. If your dishwasher door will not close, is noisy when operating, or the dishes are not cleaning properly, you might need to replace one or more of the wheels. Each wheel and axle are made of plastic, and fit into one another so they can be clipped on to the lower dishwasher rack. Many of our customers found this repair to be quick and easy, and the only tool you should need to complete the repair is a pair of pliers.

$8.47

Corner Tub Baffle - Lower Left

The corner tub baffle may also be known as the door baffle and is a part used on your dishwasher. The left and right side baffle on your dishwasher should be installed and replaced...

$8.57

Corner Tub Baffle - Lower Right

This baffle fits the lower right hand corner of some dishwashers. It is black rubber and has a matching left hand lower corner baffle. It is recommended that you replace and install both left and right at the same time. It will become evident that this part needs to be replaced if you are experiencing leaking or lack of draining. This is a very easy repair that requires no tools. Open the dishwasher door and simply use your hands to remove the baffle found in the lower right hand side of the dishwasher. Clean out any dirt and insert your new one into place.

$20.63

Water Inlet Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the de...

$123.19

Lower Dishrack with Wheels

This part includes the wheels.

$15.59

Silverware Basket

The silverware basket, used for dishwashers, is in the bottom of the dishrack. The basket is used to hold eating utensils such as spoons, forks, and knives. If the basket is worn o...

$62.13

Door Gasket - White

This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.

$18.75

Drain Valve Shaft Seal

The drain valve shaft seal is a part for your dishwasher drain pump valve. This seal creates a watertight closure around the flapper valve shaft. This part can be accessed through ...

$11.61

Interlock Switch

The interlock switch may also be referred to as a belt switch. This part is a simple on/off mechanism that prohibits the appliance from operating when the door is open. This is a part for your dryer. The interlock switch senses the door is shut and the dryer can begin. This part might need to be replaced if your dryer is not starting or is in process while the door is open. The black rectangular part of the switch is approximately 2 inches long and a 1/2-inch wide with two gold plates on either end. This is a genuine OEM part that is sourced right from the manufacturer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lower rack wheel was melted

  • Customer: Mark from Huntingdon Valley, PA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 483 of 491 people found this instruction helpful
Unsnapped clip,and moved it 90 degrees. Slip wheel and clip off. Installed clip on new wheel. replaced new wheel. The wheel did not come with a new clip and was not suggested on the parts list. The existing clip was still OK but if it was not, I would have had to order a clip and wait. All in all, a good experience. read more

The rear wheels were missing on the lower rack.

  • Customer: Teresa from Phenix City, AL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 463 of 467 people found this instruction helpful
The wheels came with a clip on part that clipped to the rack and the wheel snapped into that clip. I am a woman and it was easy for me to do. Thanks to Parts Select for being an easy to use and navigate site, for quick shipment and for good directions with the parts. Sincerely, Teresa from Alabama. read more

Water leak from gate (diverter) valve shaft

  • Customer: Joseph from Livermore, CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 126 of 136 people found this instruction helpful
This was a fairly simple repair. After disconnecting power to the dishwasher and removing the panel below the door, first had to remove a retainer C clip from the gate valve shaft. Then disconnected the linkage from the gate valve solenoid, removed two return springs and slid the gate valve contol arm off the shaft. Then removed the solenoid bracket that was... read more