Models > ADU5000C (P1188314W)

ADU5000C (P1188314W) Amana Dishwasher - Overview

Get Parts and Repair Help for ADU5000C

If you know the dishwasher repair part you need, you can browse the list of all parts on the ADU5000C, or you can search by name or part description. You can also find your part by where it is located on the ADU5000C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.82

SCREW

$6.52

Door Handle Mounting Screw Kit

$26.84

Cable & Eyelet

This part helps hold the door in place.

$3.63

CLAMP

$3.82

Ground Screw

$2.70

Screw - 6-32 x 5/16

$45.62

WHEEL

Tub Baffle - left side

This tub baffle is two inches long. It is all black in color and is made entirely of plastic. This baffle is intended for use with some dishwashers.

BAFFLE, TUB (RT)

$21.68

Lower Front Wheel

Common Symptoms of the ADU5000C [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

WOULDN"T DRAIN THE WATER COMPLETEY

  • Customer: clarence from ST LOUIS MO
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 2 of 3 people found this instruction helpful
removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...) read more

Two upper rack rollers were broken

  • Customer: Duane from Seattle WA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent. read more

Upper rack roller cracked then broke

  • Customer: Jeffrey from Wilson NC
  • Difficulty: A Bit Difficult
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
First removed the end cover and clip on the end of the rack slide. Used a flat head screwdriver to push in the clip and carefully pried it out. Then using the same screwdriver, pried up on the rack roller clip attached to the dish rack. Once clip was free of the rack, slid the rack roller off through the front of the slider. Slid the new rack roller into... read more