Models > AD40TJ0 > Instructions

AD40TJ0 Whirlpool Dehumidifier - Instructions

All installation instructions for AD40TJ0 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dehumidifier repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the AD40TJ0
1-4 of 4
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Evaporator freeze up

  • Customer: Greg from Suches GA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 5 of 8 people found this instruction helpful
Troubleshoot on the schematic/wiring diagram to find the defective thermostat. Order a replacement part. Remove all outer covers to gain access to the thermostat. Only tool needed for this is a #2 phillips screwdriver. Cut the leads on the defective part and remove thermostat and replace thermostat, wire cutters/crimper required, splice the thermostat leads, Reassemble the outer covers.

Bucket water level switch broken

  • Customer: Bert from Winston-Salem NC
  • Difficulty: Very Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
I ordered the part and, unfortunately, it was the wrong part and did not fit so I had to modify it to make it fit and finally installed it. The good news is that it works.

Push on connectors and switch housing were different

  • Customer: Lester from Brazil IN
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
The switch housing was not exactly the same for easy snap in. I removed the actual switch and installed it into the old housing. Then I found that the male pins were larger than the old ones. I chose to clip off the female connectores, strip the wires, and solder the wires to the pins on the switch. It was easier for me than attempting to change the push on connectors. For me, the actual switch was what I wanted and I fixed it my way. It was easy to do however some folks may want to change the push on connectors. Works great and saved me hundreds of dollars. Thanks.

original fan frozen so no rotation

  • Customer: BRENT from MADISON WI
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
instructions accompanying this replacement fan were great. Easily understood, correct, and instructive pics.
All Instructions for the AD40TJ0
1-4 of 4