Models > AD40DSR1

AD40DSR1 Whirlpool Dehumidifier - Overview

Get Parts and Repair Help for AD40DSR1

If you know the dehumidifier repair part you need, you can browse the list of all parts on the AD40DSR1, or you can search by name or part description. You can also find your part by where it is located on the AD40DSR1 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the AD40DSR1 [Viewing 3 of 3]

$2.70

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

$3.96

FLOAT

$56.54

Bucket and Float Kit

$2.70

Hex Nut

Part may differ in appearance, but functions same as original.

$3.83

SCREW

$32.57

Humidistat Control

$50.79

Bucket Water Level Switch

This part is used to prevent water overflow when the bucket gets full.

$3.83

Float Clip

$3.83

TIE-WIRE

$112.27

Fan Motor

This fan motor controls the circulating fan in the dehumidifier.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The origional humidistat quit working

  • Customer: James from Silver Bay MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 10 people found this instruction helpful
The knob one turns to set the humidity level was removed. The two screws holding the top on were removed. The top was lifted and swung to the side. After noting which of the two wires went where on the humidistat the wires were removed. Small flat screwdrivers were used to pry back the plastic retainers on one side of the original failed humidistat. The new ... read more

the humidity control broke

  • Customer: larry from tampa FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 13 people found this instruction helpful
Taking the case apart and replacing the control unit was a piece of cake. And the part arrived the very day after I ordered it. read more

the dehumidifier was not shutting off when water level was full

  • Customer: Steven from Owings Mills MD
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 3 of 6 people found this instruction helpful
replaced a piece of the plastic at the top of the bucket that seems to be the water gauge. this seems to be fixed. we are very happy read more