Models > AD25BBL0

AD25BBL0 Whirlpool Dehumidifier - Overview

Get Parts and Repair Help for AD25BBL0

If you know the dehumidifier repair part you need, you can browse the list of all parts on the AD25BBL0, or you can search by name or part description. You can also find your part by where it is located on the AD25BBL0 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the AD25BBL0 [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Hex Nut

Part may differ in appearance, but functions same as original.

$3.96

FLOAT

$2.70

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

$56.54

Bucket and Float Kit

$37.92

Humidistat Control

$3.54

TIE-WIRE

$2.70

Float Clip

$4.11

SCREW

Castor

Also known as wheel or roller. This part is sold individually.

PAN-DRAIN

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The origional humidistat quit working

  • Customer: James from Silver Bay MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 4 of 6 people found this instruction helpful
The knob one turns to set the humidity level was removed. The two screws holding the top on were removed. The top was lifted and swung to the side. After noting which of the two wires went where on the humidistat the wires were removed. Small flat screwdrivers were used to pry back the plastic retainers on one side of the original failed humidistat. The new ... read more

the humidity control broke

  • Customer: larry from tampa FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 3 of 6 people found this instruction helpful
Taking the case apart and replacing the control unit was a piece of cake. And the part arrived the very day after I ordered it. read more

The dehumidifier did not turn off automatically when the collection bucket was full (or removed).

  • Customer: Michael from Madison NC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 1 people found this instruction helpful
The microswitch that senses a full or missing collection bucket can almost be removed without taking off the cover of the dehumidifier, but the arrangement and orientation of connector contacts makes that very difficult. It took me five minutes to remove the cover (Phillips head screwdriver), 30 seconds to replace the switch, and a few minutes to re-install... read more