Models > ACG150NCW1

ACG150NCW1 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for ACG150NCW1

If you know the refrigerator repair part you need, you can browse the list of all parts on the ACG150NCW1, or you can search by name or part description. You can also find your part by where it is located on the ACG150NCW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ACG150NCW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ACG150NCW1 [Viewing 3 of 3]

$42.04

Door Shelf Retainer Bar

This is a white cut-to-fit door shelf retainer bar.

$4.06

Door Shelf End Cap - Right Side

This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.

$3.37

Door Shelf End Cap - Left Side

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$6.87

SOCKET-LIGHT/LAMP

$3.27

Door Shelf End Cap - Right Side

$5.20

Hexagonal Screw

$5.52

Hex Head Screw

$47.27

Fresh Food Door Gasket

This almond fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$2.40

Ice Cube Tray

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Light socket melted around bulb

  • Customer: William from Alexandria VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 18 of 29 people found this instruction helpful
After unsuccessfully trying to change the blown light bulb I discovered that the plastic light socket had gotten so hot that it melted and permanently fused with the blown bulb. After my new socket arrived in the mail I just popped the temp control assembly out with a screw driver and removed the old socket and placed the new one in. Whole operation to 5... read more

Freezer stopped freezing food.

  • Customer: FREDDIE from WHITAKERS NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 8 of 10 people found this instruction helpful
I unplugged electrical cord to the freezer. I removed the cover to the relay and load protector. I labeled the wires and made a diagram on the proper placement of each wire going to the relay. I unplugged each wire and removed the relay. Then I removed the load protector. I installed the new load protector and new relay. I placed the wires on the proper term... read more

Drip pan had rusted & was leaking water on the floor

  • Customer: John from Forest VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Wrench(Adjustable)
  • 4 of 5 people found this instruction helpful
The BIG problem was getting the old drip pan off. The bolt on top of the compressor was too long to allow the removal of the old drip pan. I removed the old drip pan by cutting most of it away with tin shears then cutting the remaining part of the pan around the bolt with a hack saw (taking care not to damage freon lines and raising the pan above the threads... read more