Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ACB6260AS

ACB6260AS Amana Wall Oven - Overview

Get Parts and Repair Help for ACB6260AS

If you know the wall oven repair part you need, you can browse the list of all parts on the ACB6260AS, or you can search by name or part description. You can also find your part by where it is located on the ACB6260AS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for ACB6260AS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$29.46

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$59.02

Door Glass with Tape

Lower Relay Board with Harness

$4.02

Door Glass Spacer

Sold individually.

Door Lock Switch

This door lock switch is two inches long. It is a black and metallic switch that carries 120 volts.

Glass Door Foil Tape

This piece of foil tape is twenty-nine and a half inches long. It is three inches wide and adheres to the inside top of a range's glass door.

INSULATION

USE WPL 3605F236-50

EXTENSION-

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 105 of 121 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 45 of 56 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

Oven door wouldn't close completely

  • Customer: William from Statesville, NC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 27 of 30 people found this instruction helpful
Parts arrived in three days and it was an easy swap of the hinges but the same problem still existed: the oven door wouldn't close completely, so the oven light stayed on and the convection wouldn't work either unless the door closed all the way. The replacement hinge's springs apparently aren't strong enough to close it and the springs aren't adjustable - w... read more