Models > ABB222ZDEQ

ABB222ZDEQ Amana Refrigerator - Overview

Get Parts and Repair Help for ABB222ZDEQ

If you know the refrigerator repair part you need, you can browse the list of all parts on the ABB222ZDEQ, or you can search by name or part description. You can also find your part by where it is located on the ABB222ZDEQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ABB222ZDEQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

Order within the next 1 hr and 45 mins and your part ships today!
$103.07

Replacement Ice Maker

NOTE: This replacement ice maker mechanism does NOT come with a cover,shut off arm, a wire harness, or the mounting hardware. Must be ordered separately.

Order within the next 1 hr and 45 mins and your part ships today!
$2.70

Screw

This screw is sold individually.

Order within the next 1 hr and 45 mins and your part ships today!
$36.81

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

Order within the next 1 hr and 45 mins and your part ships today!
$67.27

Compressor Start Device and Capacitor

The capacitor helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. The start relay boosts the compressor, and then s...

Order within the next 1 hr and 45 mins and your part ships today!
$7.37

Water Tube Kit

This tubing is 1/4'' in diameter and comes with 2 inserts. This tubing may be longer than the original, and may have to be cut.

Order within the next 1 hr and 45 mins and your part ships today!
$18.84

Light Switch

This part turns on the light when the door is opened.

Order within the next 1 hr and 45 mins and your part ships today!
$15.21

Water Fill Cup and Bearing

Order within the next 1 hr and 45 mins and your part ships today!
$5.74

SCREW

Sold individually.

Order within the next 1 hr and 45 mins and your part ships today!
$17.83

Fan Blade

Used with Evaporator Fan Motors.

Order within the next 1 hr and 45 mins and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Icemaker producing few or no cubes and often leaving "kling-ons" on ice tray

  • Customer: Bernie from Diamond Bar CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 590 of 609 people found this instruction helpful
Interior surface of ice tray felt rough & flaky (coating deteriorated) so cubes would not release.
Unplug appliance.
Remove timer cover by hand pressure @ edge.
Remove single attachment screw & bracket at lower front of icemaker.
Disconnect wiring harness from socket @ rear of compartment.
Tricky part was determining what type of con... read more

Freezer is cold, Refridgerator is not as cold as it should be

  • Customer: Russell from Hardinsburg KY
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 216 of 261 people found this instruction helpful
Having seen this problem before in other equipment so I had an idea where to look. Problem: the automatic defrost function was not operating. Looking through openings in the back panel of the freezer compartment, you could see the evaporator coils and fins were a solid chuck of ice. There are three logical components to check. Heater element, thermostat ... read more

The compressor would not run.

  • Customer: Gilbert from Clinton MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 204 of 230 people found this instruction helpful
I removed the screws in the lower back panel where the compressor is located. Then I unplugged the capacitor and plugged the new one in. I then checked to see if the compressor would start. It wouldn't so I replaced the overload relay with capacitor and that fixed the problem. The capacitor just plugs into the relay then plugs into the compressor. There are ... read more