Models > ABB1921DEW14

ABB1921DEW14 Amana Refrigerator - Overview

Get Parts and Repair Help for ABB1921DEW14

If you know the refrigerator repair part you need, you can browse the list of all parts on the ABB1921DEW14, or you can search by name or part description. You can also find your part by where it is located on the ABB1921DEW14 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ABB1921DEW14 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$13.64

Center Crisper Rail

Actual measurements are: Length 13" Width 2" Height 1.5"

$2.70

Screw

This screw is sold individually.

$63.61

START-DEV

$68.29

Dual Water Inlet Valve

The water inlet valve is a solenoid-operated switch that, when activated, releases water from the supply line to the water valve and into the compact icemaker mold and to the water line.

$4.46

Toe Grille Clip

$18.45

Light Switch

$18.32

Water Fill Cup and Bearing

$42.93

Freezer Door Handle

The screws for this white handle are sold seperately.

$32.62

Defrost Thermostat

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the...

$3.86

Touch-Up Paint - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The refrigerator was not getting cold and the coils were not defrosting.

  • Customer: Cheryl K from Pinellas Park FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 51 of 57 people found this instruction helpful
Start by removing the freezer door and inner baskets so you have some space. Next, take out the ice maker by removing the 3 screws that attach it to the side and unplug it from the harness. Then the cover for the thermistor and the fan vent should be popped off carefully leaving the back cover only. The back cover is held on by 4 screws, one in each corne... read more

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 47 of 60 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

Cracked & Snapped Center Crisper Rail

  • Customer: Ruth from Roxbury MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 40 of 41 people found this instruction helpful
A very easy fix took all of five minutes read more