AAV2200AGW Admiral Washer - Instructions

Unplug. Open the front panel (2 clips, 2 hex head metal screws), remove the two hose clamps and hoses from the pump, remove 3 hex head screws holding the pump...bingo.. in with the new pump, hoses and panel go back....put the drive belt back on...the wife is back in buisness.. Note to all husbands out there, mess up on a few loads of laundry (mix red with white and her unmentionables turn a hideous pink) and you never have to do laundry again !!!!
Tip to all, if you have a wet-vac, attached it to the discharge hose of the washer to remove the standing water in the pump.

Right part, right price, delivered right on time Thank you Parts Select

got the right part great service from partselect invited my bro in law 20 mins we where done.. no more violent shaking spin cycle thank you very much

1. Open washer lid.
2. Remove right hinge mounting screw by leaning agitator/tub assembly to the right.
Do the opposite for the left hinge mounting screw.
3. Remove and replace both hinge pins on the lid.
4. Install both hinges on the pins and install lid back on the washer.

I got the part the very next day, very easy to replace. Replaced the belt as well. Parts Select is the best. Vert straight forward repair.

found your web site and the helpful hints Thank you it works wonderful even washing heavy loads

I replaced the water pump and belt. The part you sent me was an exact match, so I had no problems what-so-ever fitting the new part into place.

Thanks

looked at the digram on partselect and did the repair

turn off water to washer, disconnected hoses. Tilted over to open rear access panel removed old worn part replaced with new part reattached pulley. Replace access panel flipped back in operation position. Connected hose turned on water. Put small load in and turned on washer worked great.

I used Utube to search for Performa Washing machine jumping around. You will find several videos that will be extreamly helpful in understanding exactly how to go about changing the sunbber ring. The snubber ring is fairly easy to change out. Quarters were used to hold the springs apart so they can be removed. Push the tub forward and away from the spring you want to remove. Install several quarters in the spring. Use as many as you can get in. Then pull the tub toward you and the spring can be removed from the tub. There are six springs to remove. I just left them laying in place at the bottom of the washing machine base. There are videos on utube also of using the quarters to remove the springs. Of course if you have spring removal tool for this purpose so much the better. I didn't have one. Good luck with your install. MB in TN

I heard buziing and smelled a burning smell with my washer so i got on your website and watched a video how to take the washer apart and what the problems could be and determined it was the drainpump so i took the 3 bolts holding it on out and inspected the belt while i had it off , and ordered the part from you guys and put it on your information was very helpful

Just like your video explained

Repalced snubber ring and springs according to instuctions provided by partselect. Excellent instructions.

The repair was easy. 5 minutes after grabbing my tools the job was done. It was easy to find the part I needed on the web site.

..watched the video..easy as pie..took longer to figure out what part was making noise than to fix..

When I received the replacement part it did not look exactly the same as the one that came off the washer. After watching the video that was sent with the shipment confirmation I very clearly understood it and was able to do repair in about 10 minutes. It was so easy, I wish that there were more repairs to do to take advantage of your wonderful customer service. You have created a customer for life. Thank you