Quick Question!

Have you ever purchased from PartSelect.com before?

Models > A8241RA-L

A8241RA-L Admiral Cooktop - Overview

Get Parts and Repair Help for A8241RA-L

If you know the cooktop repair part you need, you can browse the list of all parts on the A8241RA-L, or you can search by name or part description. You can also find your part by where it is located on the A8241RA-L by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.89

SCREW

Sold individually.

$66.72

Burner Grate Kit

This kit includes 4 black burner grates.

SCREW

PANEL, CONTROL (BLK)

$21.94

Power Cord

TAPE- FOAM

PALNUT

$80.80

REGULATOR

$4.89

BUSHING- S

GASKET, BURNER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner wouldn't start

  • Customer: Yury from Brooklyn, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 29 of 42 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

burner head was rusted out. ordered 1 to see if part was correct. ordered 4 more to finish job.

  • Customer: Robert from Somerville, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 13 of 17 people found this instruction helpful
unscrewed old burner head ;disconnected 2 wires; repaced with new burner head and replaced wires. Unfortunately, before we really needed to replace the other burner heads, the cooktop itself developed a gas leak. We decided to replace the whole thing, and therefore would like to return the unboxed, unused 4 remaining burner heads. read more

Igniter Switch on the burner was constantly on

  • Customer: Roman from West Caldwell, NJ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 7 of 13 people found this instruction helpful
To get to the switch I had to remove the knobs and the front panel of the burner valves. There were some dozen screws, top and bottom holding the panel in-place.
The switch slid off the burner valve stem easily but removing the wires I had to pull with the pliers. There seamed not to be a wire release that I could see.
Replacing the wires was no p... read more