A8240 Maytag Washer - Parts
Keep searches simple, eg. "belt" or "pump".
Tub Bearing Kit
PartSelect #: PS2347235
Manufacturer #: 6-2040130
This kit is used on 2-belt washers. It is recommended to change the seal kit at the same time. The tub bearing kit fixes issues with leaking, loud noise, excessive shaking/moving or if your pump is no...
$55.59
In Stock
Syphon Break Elbow Kit with Clamp
PartSelect #: PS2017573
Manufacturer #: 208847
For drain hose 7/8".
$26.53
In Stock
Lid Check Switch
PartSelect #: PS11738787
Manufacturer #: WP207166
This lid switch check is used in washers to detect if the washer lid is open or closed. This prevents a cycle from spinning when the lid is still open and is also used to start your washer once a cert...
$48.41
In Stock
Lid Switch Assembly
PartSelect #: PS11739302
Manufacturer #: WP22001682
This black lid switch assembly comes complete with a bracket, two switches, and a fuse. An open fuse might indicate that the lid switch is bad. The point of the lid switch is for the tub to stop spin...
$42.42
In Stock
Adjustable Leveling Leg
PartSelect #: PS2021026
Manufacturer #: 22003428
If your washer shakes or vibrates loudly when it reaches its max speed, make sure the 4 levelling legs are even. Adjust the legs so that the machine is level, and tighten the locking nuts on the legs ...
$18.47
In Stock
Spring Retaining Clip
PartSelect #: PS11739294
Manufacturer #: WP22001650
This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than ...
$11.10
In Stock
Siphon Break Connector Kit
PartSelect #: PS2017342
Manufacturer #: 206638
This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines.
$73.04
In Stock
Injector Sleeve
PartSelect #: PS11738910
Manufacturer #: WP215447
This is a top mounting style injector sleeve.
$11.14
In Stock
Hose Clamp
PartSelect #: PS11740613
Manufacturer #: WP285655
The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installat...
$11.10
In Stock
Damper Pad Kit
PartSelect #: PS2017036
Manufacturer #: 203956
This damper pad kit is used for base support. It comes with three six inch damper pads, two little tubes of lubricant. NOTE: This part will need adhesive to stick it in place.
$45.24
In Stock
Washer Lid Bumper
PartSelect #: PS11738875
Manufacturer #: WP212716
This washing machine lid bumper is just under an inch long. It is all gray in color and is made entirely of rubber.
$7.70
In Stock
Heat Resistant Adhesive
PartSelect #: PS11728058
Manufacturer #: W10841140
This is a heat-resistant adhesive for your appliance. The heat resistance allows you to stick parts such as grate feet, gaskets, and felt seals in hot areas, such as a cooktop, without compromising th...
$23.85
In Stock