Models > A79E-5CXW

A79E-5CXW Admiral Oven - Overview

Get Parts and Repair Help for A79E-5CXW

If you know the oven repair part you need, you can browse the list of all parts on the A79E-5CXW, or you can search by name or part description. You can also find your part by where it is located on the A79E-5CXW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for A79E-5CXW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the A79E-5CXW [Viewing 4 of 4]

$2.52

Light Bulb - 40W

Sold individually.

$55.94

Bake Element - 240V

This spade-style bake element has push-on wire terminals and is found on the bottom of the oven.

$2.77

Screw - sold individually

$3.96

Lamp Retainer Gasket

$13.25

Clock Knob

Sold individually.

$33.50

Oven Rack

$98.09

Interior Door Glass Window Assembly

$45.21

Door Handle

Screws are not included.

$3.86

Hinge Pin

$2.70

Door Glass Spacer

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

bottom heating element in oven disintegrated

  • Customer: DENISE from GERMANTOWN TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 19 of 21 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I threw away the old pieces.

Then I connected the two wires on the new element. I pushed the wires back in the insulation in the wall of the cabinet. Then I inserted the two screws and tightened them in.read more

Oven heating element blew out

  • Customer: Shirley from Dallas TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 9 of 10 people found this instruction helpful
Removed 2 screws, pulled element out. My husband used an ohmmeter to see if the electricity needed to be turned off. It showed no voltage. He could not remove electrical connectors by hand, so he used insulated pliers. When he touched the connectors, a shower of sparks covered the inside of the oven and tripped the breaker switch. Then we noticed the pl... read more

Element was burned through

  • Customer: Kevin from New London OH
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 6 people found this instruction helpful
I used tiny amount of WD40 on old screws,let sit for 2 minutes. Tapped the screws(2) of them with a small hammer to wake them up, I had a cordless drill and they backed right out. Pulled the old element out, used needle nose pliers to pull connectors off of the element(wiggle gently) put the new element on, reinserted back in the oven,attached with new screw... read more