A3316ABSARBB General Electric Refrigerator - Instructions

I'm not at all techie, but your site made it easy for me to find the part I needed. The part arrived within 2 days, and walla I installed and all is good.

Thanks, I only wish every internet search was this easy.

The new one not only arrived faster than I expected but it was also a lot sturdier, nice shape and the fridge looks cleaner. Also it offers better support for what I store right on it.

same

Removed the old cracked shelf and slipped in the new one. Fit perfectly. Should have done this years ago !!!!

First I removed the old cover, and the cans of soda I was using to hold it up. Then I put the new cover in, and snapped it in place. This took less than a minute, and could not have been easier. The replacement cover fits perfectly. Thanks!!

We thought we would have to replace our frig, but found the part online and it fit perfectly. It's slightly different than the original because it is stronger. All we did was remove the items from the tray, unsnap the broken one and slide the new one into place.

Removed the back of the freezer, 4 screws, and then unscrewed the motor mount with fan and motor attached. Switched fan blades to new motor. Reinstalled motor mounting then back of freezer. I had to go buy the ring opener tool at the auto parts store. $12.

Using plyers Pulled old switch down and out. Put new one in and pushed new switch up into position. The switch plugs into the contacts, no wiring needed. Worked like a charm. You saved me 200 dollars GE repair bill. Thanks

all I had to do is remove the broken cover then replace the new one which only took about 2 minutes. It was so easy and it is a little more durable than the original one.

Removed the old pan cover, which lifts out very easily, and replaced with the new one. I had to install the two plastic washers, that came with the kit, at the bottom of the refrigerator door around the hinge pin. To avoid having to take the door off to install the washers, I cut a piece out of each washer big enough to fit onto the hinge pin. I first lifted the door up and placed a support underneath and then I snapped the washers onto the pin. This was done so the door would close properly. Installation instructions were enclosed with the shippment. Installation was less than 15 mins.

removed the inside fridge electrical panel and swapped switches

Replaced the cover.

I followed the video instructions and the job was done in no time at all

I took out the old cover and slid the new one in place. Unbeievably easy. The old cracked cover was palpably a poorer-quality item than the replacement. The box from PartSelect also included some rubber washers in case the new cover impeded door closing, but it did not. Thank you very much, PartSelect!

1) This is a built-in refrigerator with the compressor, coils, etc. at the top. Turn off the breaker to the fridge. 2) Remove the front panel off the top (just push up and pull out). 3) Removed 2 screws to the old timer and carefully remove the plug. Plug the new timer in and screw in. 4) Since our fridge was heavily frosted up, we moved everything to another refrigerator and coolers and kept the refrigerator off until all panels were room temperature. 5) If you haven't cleaned the coil in a while, vacuum it with a soft brush attachment. 6) Turned back on and the refrigerator is cooler than ever!