Models > A125B

A125B Jenn-Air - Overview

Get Parts and Repair Help for A125B

If you know the repair part you need, you can browse the list of all parts on the A125B, or you can search by name or part description. You can also find your part by where it is located on the A125B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Exact Part matches for your search term [Viewing 1 of 1]

$346.49

MODULE

This part number matches the current model number "A125B".

Sections of the A125B [Viewing 1 of 1]

$3.76

Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

$63.72

Radiant Surface Element with Limiter - 6" - 1200W

$28.21

Burner Cartridge Terminal Block

No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.

$4.60

SCREW

$4.60

Terminal Block Insulator

This part fits inside your range's terminal block to act as an insulator for the contact spade.

$3.83

SCREW

$2.70

Screw

This screw is sold individually. Size: 8-32 x 1/4 inch.

CLIP

This wiring clip is an inch long, and is made entirely of metal. This clip is used with ranges and cooktops.

USE WPL 5700M527-60

$23.59

SUPPORT

Common Symptoms of the A125B [Viewing 1 of 162]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

6" burner on the radiant surface started smoking and burned out.

  • Customer: Johnny from Henderson NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 12 of 18 people found this instruction helpful
Remove plug in unit from stove top. Turn over and remove the 7 screws from the 4 sides only. Turn back over holding unit together manually. Remove the glass top gently and lay it aside. Remove two wires that are plugged into the old unit, remembering which belongs where. You might want to remove one at a time and connect to new unit. Place new unit in ... read more

The top would not heat,large or small eye.

  • Customer: Calvin from Merced CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 9 of 15 people found this instruction helpful
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder. read more

cook top module would not heat.

  • Customer: Daryl from Olathe KS
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 4 of 4 people found this instruction helpful
The contact spades were burned from 10+ years of use and the cook top module was worn. I disassembled the module, taped the top to protect the creamic cook top, sanded the metal and spray painted to restore the original white finish. On the bottom half I replaced one missing pop rivet and cleaned and spray painted the bottom to restore to the original black.... read more