Quick Question!

Have you ever purchased from PartSelect.com before?

Models > A104 > Parts

A104 Maytag Washer - Parts

All parts for the Maytag Washer A104

Below is a list of all parts for the Maytag Washer A104 - Top Loading. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the A104
15-28 of 228
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$86.67

Drain Pump

This assembly uses 2 belts. Order belts if you notice wear and tear.

$25.98

Siphon Break Connector Kit

This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines.

$7.36

Injector Sleeve

This is a top mounting style injector sleeve.

$4.63

Spring Retaining Clip

This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than usual during the wash cycle, your spring retaining clip could be faulty or damaged. Check the clip for visible damage, wear, and rust. If you notice any signs of damage, the part should be replaced. Remember to disconnect the power from your washing machine before starting this repair.

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washe...

$4.63

Tension Springs -Set of 2

This is a set of 2 tension springs.

$27.53

Glide and Spring Kit

This glide and spring kit contains two three inch springs, four one inch square glides, and two tubes springs. This kit replaces older style round roller glides.

$3.02

Screw

Sold Individually.

$5.77

Screen

Found on the water inlet valve.

$33.48

Injector Hose

This washing machine injector hose runs from your washer's inlet to its injector. It is black and made of rubber. It is also available in an injector kit.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$4.48

Inlet Hose Washer

This inlet hose washer, also known as a high pressure inlet hose washer, is used in washing machines, refrigerators, freezers, and dishwashers. The function of this part is to create a watertight seal in the appliance. If your gasket gets dry and brittle over time it will start to crack and will lose its function. In this case, it is important to replace it. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance. As a safety precaution, remember to unplug your washer from the power source before beginning.

$65.52

Timer Motor - 120V 60Hz

$21.34

Outer Tub to Pump Hose

All Parts for the A104
15-28 of 228