A103 Maytag Washer - Instructions

I was only missing one of the bumpers but that was in pretty poor shape so I replaced them both. It didn't take much to do. Just pressed the bumper into place and Viola! instant gratification.

Took all the parts related to the drive shaft and replaced the tub seal. We also replaced drive and pump belts due to an overheating smell coning from washer a couple months back.

After removing the front cover and draining the tub, I replaced the drain pump and the washer works as good as new.

I watched the YouTube video twice and it was just as easy as in the video. No problems. I ran a couple of test loads and it was back working like a champ. My parents had their belt changed by a repair man and it cot them $150 (pretty reasonable). This whole repair cost only $45 and 15 minutes (including the video watching time!). It pays to do the simple things.

I unplugged machine and removed water and clothes. Tipped washer bback to gain acccess to belts, which slipped off and back on quite easily. Put washer back in place, plugged in and continued washing clothes. Simple!

Being mechanically inclined, I found this repair pretty straight forward. First, watch the video and keep returning to it to double check yourself. Second, find someone with the spanner wrench, or purchase one. I called a appliance repair shop, and they loaned me one with a refundable deposit. My only compliant is the the out side tub bolts have a rubber washer that is not included with the repair parts kit. Inspect the rubber or find replacements. As the video explains, "TIGHTEN THE NUTS not the BOLTS", this will keep the old rubber washers from twisting. Recommend replacing your transmission shaft bearing and wash tub seal at the same time, If you can afford them.

Just tilt the washing machine, take out the old and put back the the one its so easy. You don't have take out anything.

I followed the video provided. The video was very clear and helpful.

My wife did the repair. Went on your website and watch the video on how to replace the switch and she was able to do it herself. I didn't mind at all. Saved $75.00 service charge.

followed video from your website. Nut does not come off as easy as your video shows.

watched video, ordered parts, parts arrived fast in two days, watched video again, Repaired washer saved money

Remove front panel removed two screws holding top down, then removed plastic tube cover, removed balancer to make more room to work. Next removed set screw holding dasher, next remove spanner nut that held inner tube shield. Tthen lifted inner tube out of washer, now I removed the stem hold down and seal important clean area where seal touches the tube nowuse little water to wet new seal pt new seal ln careful not to damage simply reverse removal step and put the unit back together

contacted Justanswer.com with description. Expert defined problem, identified part need and gave us link to your website. Rapid arrival of part, but we took a couple of weeks to get around to it as the washer was operational, just noisy. Website video of how to do repair was invaluable. Watched prior to starting the job and checked video again during repair to verify understanding. Wonderful to be independent of the vagaries of appliance repair. I would recommend Justanswer and PartSelect to anyone!

Exactly as shown in your provided video from You Tube. What a life saver. The description of needed tools, and the fact that the main nuts securing the tub were REVERSE thread! I would not have suspected that and probably would still be beating on them, tightening them rather than loosening them!It is worth the price to purchase the spanner wrench (correct style), used to remove those tub nuts. Thanks for the great service and the video. Well done!

I found on youtube that there are directions to repair. Dryer problems are usually one of three things, the door switch being one of them. i checked this last (should have been first). ordered the part( about 65% off sear's cost) and it came in one day! It went on really easy as long as you knew from repair video how to access inside. almost spent $400.00 on a new one.