Models > A100W Maytag

A100W Jenn-Air Cooktop - Overview

Get Parts and Repair Help for A100W

If you know the cooktop repair part you need, you can browse the list of all parts on the A100W, or you can search by name or part description. You can also find your part by where it is located on the A100W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for A100W parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Exact Part matches for your search term [Viewing 1 of 1]

$258.93

Cooktop Cartridge with Coil Elements - White

This part number matches the current model number "A100W".

This cartridge has the end plug-in.

Sections of the A100W [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.27

Drip Bowl - Chrome - 8"

Sold individually.

$8.79

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$6.87

Drip Bowl - 6"

Sold individually. This part is located beneath the element and catches any spills.

$26.84

Surface Element - 8"

This burner with reinforced delta frame carries 2100W and 240V.

$24.23

Electric Surface Element - 6"

This surface burner with reinforced delta frame carries 1250W and 240V.

$5.30

Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

$2.73

Screw - 6-32 x 5/16

Sold individually.

$21.54

Burner Cartridge Terminal Block

No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.

$4.70

SCREW

$4.70

Terminal Block Insulator

This part fits inside your range's terminal block to act as an insulator for the contact spade.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 111 of 121 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

The top would not heat,large or small eye.

  • Customer: Calvin from Merced CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 14 of 21 people found this instruction helpful
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder. read more

no contact -burner male to female in unit.

  • Customer: Shalom from Brookfield CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 6 of 7 people found this instruction helpful
the replacement fit well. the burner is ok. if i need to change the female part receiving the prongs, what do i do?
or maybe there's another reason. [as, naturally one must pull it out to clean.] read more