Models > A100B-C

A100B-C Jenn-Air - Overview

Get Parts and Repair Help for A100B-C

If you know the repair part you need, you can browse the list of all parts on the A100B-C, or you can search by name or part description. You can also find your part by where it is located on the A100B-C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . We’ve also included any installation videos we have for A100B-C parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the A100B-C [Viewing 1 of 1]

$10.15

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$26.84

Surface Element - 8"

This burner with reinforced delta frame carries 2100W and 240V.

$40.05

Electric Surface Element - 6"

This surface burner with reinforced delta frame carries 1250W and 240V.

$3.76

Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

$23.12

Burner Cartridge Terminal Block

No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.

$4.60

Terminal Block Insulator

This part fits inside your range's terminal block to act as an insulator for the contact spade.

$3.82

Screw

This screw is sold individually. Size: 8-32 x 1/4 inch.

$99.36

Cartridge Cooktop - Black

$2.70

Screw - 6-32 x 5/16

$4.60

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 98 of 107 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

The top would not heat,large or small eye.

  • Customer: Calvin from Merced CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 12 of 19 people found this instruction helpful
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder. read more

Burner was out but the burner coil worked on onother burner

  • Customer: Richard from Orange CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 5 people found this instruction helpful
Replaced receptacle but it was not the problem. After further inspection I believe that the problem is the switch. The switch is on order now from Part Select. read more