Quick Question!

Have you ever purchased from PartSelect.com before?

Models > A100B-8

A100B-8 Jenn-Air Cooktop - Overview

Get Parts and Repair Help for A100B-8

If you know the cooktop repair part you need, you can browse the list of all parts on the A100B-8, or you can search by name or part description. You can also find your part by where it is located on the A100B-8 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for A100B-8 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the A100B-8

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.21

Surface Burner Receptacle Kit

The tools you will need to replace the surface burner receptacle kit on your range include a Phillips screw driver, and a pair of wire strippers. Before doing this repair, make sur...

$10.16

Drip Bowl - 6"

The drip bowl is found under the 6-inch burner on your range. This square chrome stove top drip pan is intended for use with electric ranges. It has a 2-inch inner hole diameter and 7-inch outer diameter. Drip bowls should be cleaned regularly, and replaced when too much food and debris has been burned or stuck to it, making it too hard to clean. You should replace your drip pan if it is rusted or damaged. Grease, oil, and food can spill into your unit and become a fire hazard. This drip pan is dishwasher safe and is sold individually.

$7.54

Drip Bowl - Chrome - 8"

This is a drip bowl, and it is used in conjunction with your range. The function of this part is to sit underneath your stove top burner element. This will allow the bowl to catch ...

$6.31

Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

$25.20

Burner Cartridge Terminal Block

No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.

$36.36

Element Receptacle Assembly

This part connects the surface burner to the wiring harness.

$4.94

Screw

$3.02

Screw - 6-32 x 5/16

This screw is well under an inch long, and is made of metal.

$3.75

Screw

This screw is sold individually. Size: 8-32 x 1/4 inch.

$104.91

Cartridge Cooktop - Black

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 152 of 163 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Range element receptacle had shorted out

  • Customer: Daniel from Great Falls, VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 18 of 22 people found this instruction helpful
(1) Disassembled range element cartridge unit by removing six machine screws on sides
(2) Removed old element receptacle assembly (note screww attaching the clip to ring was corroded and had to be drilled out and replaced - screw not included), retaining existing element (determined it was good)
(3) Fited up new element receptacle assembly and dete... read more

The top would not heat,large or small eye.

  • Customer: Calvin from Merced, CA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 19 of 31 people found this instruction helpful
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder. read more