Models > 9KSM5CBBK1

9KSM5CBBK1 KitchenAid Mixer - Overview

Get Parts and Repair Help for 9KSM5CBBK1

If you know the mixer repair part you need, you can browse the list of all parts on the 9KSM5CBBK1, or you can search by name or part description. You can also find your part by where it is located on the 9KSM5CBBK1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your mixer. We’ve also included any installation videos we have for 9KSM5CBBK1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Retaining Ring

$4.60

Worm Gear

Used in Mixers.

$25.30

Grease - Approx. 1 pound

This grease is used for the Kitchenaid stand mixers for the planetary gears.

$10.35

Worm Gear and Bracket

$2.70

Thumb Screw - Black

This part is used with the stand mixers attachments, as well as to hold the end cap to the front of the mixer.

$15.94

Flat Mixer Beater

This part fits the Kitchenaid K5 series mixers.

$2.70

Retaining Pin

This part works in conjunction with the worm and bevel gear.

$7.77

Speed Control Plate

Used in Mixers.

$4.46

Transmission Case Gasket

$3.91

Spring Latch

Used on stand mixers to help keep the bowl in place.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Speed Control Lever KNOB BROKEN

  • Customer: Robert from Minot ND
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 46 of 64 people found this instruction helpful
Pulled the Knob off of the new Lever then pressed it on the old Lever. I had to order the whole lever because it was the part nearest the knob in the illustrated parts break-down. I RECOMMEND THAT THE KNOB BE ADDED TO THE ILLUSTRATED PARTS BREAK-DOWN. read more

motor would run but mixer wouldn't operate: broken worm gear

  • Customer: Raymond from Shirley MA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 31 of 33 people found this instruction helpful
My girlfriends' stand mixer failed when the accessory drive cap fell into the mixing bowl and jambed the beater, spliting the worm gear. The teeth on this gear are made of nylon and are molded to an aluminum center. This part is designed to fail in situations like this, saving the more expensive transmission parts. Following a repair manual I found online, I... read more

Leaking Oil

  • Customer: Alice from Fort Myers FL
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 19 of 21 people found this instruction helpful
This was my husband's first time to taking apart any mixer - much less a heavy duty KitchenAid. Since we could not find a local repairman, the only thing to do was try to repair it himself. Using your exploded view of the machine he found on the internet, he ordered a gasket which he felt would be needed to repair the mixer. When he tore the machine down, th... read more