Models > 9815VUV

9815VUV Magic Chef Oven - Overview

Get Parts and Repair Help for 9815VUV

If you know the oven repair part you need, you can browse the list of all parts on the 9815VUV, or you can search by name or part description. You can also find your part by where it is located on the 9815VUV by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for 9815VUV parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 9815VUV [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$35.74

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$53.76

Bake Element - 240V

This spade-style bake element has push-on wire terminals and is found on the bottom of the oven.

$2.70

Screw

This screw is sold individually.

$26.73

Light Lens

$33.50

Oven Rack

$2.70

Single Glass Retainer Clip

$45.91

ELEMENT, BROIL 3000W 4PA

$4.60

Screw

This screw is sold individually.

$98.09

Interior Door Glass Window Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 56 of 60 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 18 of 21 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

bottom heating element in oven disintegrated

  • Customer: DENISE from GERMANTOWN TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 17 of 19 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I threw away the old pieces.

Then I connected the two wires on the new element. I pushed the wires back in the insulation in the wall of the cabinet. Then I inserted the two screws and tightened them in.read more