Models > 95-1982-23-01

95-1982-23-01 Tappan Refrigerator - Overview

Get Parts and Repair Help for 95-1982-23-01

If you know the refrigerator repair part you need, you can browse the list of all parts on the 95-1982-23-01, or you can search by name or part description. You can also find your part by where it is located on the 95-1982-23-01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 95-1982-23-01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$12.91

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fah...

$42.04

Door Shelf Retainer Bar

This is a white cut-to-fit door shelf retainer bar.

$4.06

Door Shelf End Cap - Right Side

This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.

$3.37

Door Shelf End Cap - Left Side

$24.55

Evaporator Fan Motor Kit

This motor runs the evaporator fan in your refrigerator. It is mounted on the center hub and has three lead wires terminals. This motor rotates in a clockwise fashion. Its shaft ha...

$4.16

Freezer Shelf End Cap

Sold Individually. These fit on the tips of the shelf to keep it from sliding forward.

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$6.87

SOCKET-LIGHT/LAMP

$23.91

Evaporator Fan Blade

$5.20

Hexagonal Screw

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Noisy fan

  • Customer: Jordan from Maumee OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 56 of 65 people found this instruction helpful
1. Removed the 7 nuts using the nut driver from the freezer back panel inside the freezer.
2. Remove the back panel. The evaporator motor and fan are located above the coils.
3. Unplug the wiring harness.
4. Remove the two gold mounting screws holding the motor and fan in place.
5. Remove the motor and fan including the brackets.
6. ... read more

Refrigerator ran frequently and freezer door was sagging

  • Customer: Dale from Pevely MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 26 of 32 people found this instruction helpful
I pulled off the old door gasket which came off really easy. I was hoping the new one would go on as easy as just popping it in place but it didnt work. I had to remove the inside door panel. The gasket wouldnt lay entirely flat in the inside groove so I used a bead of RTV around the entire circumference which helped to hold it in place while reattaching the... read more

Light socket melted around bulb

  • Customer: William from Alexandria VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 21 of 33 people found this instruction helpful
After unsuccessfully trying to change the blown light bulb I discovered that the plastic light socket had gotten so hot that it melted and permanently fused with the blown bulb. After my new socket arrived in the mail I just popped the temp control assembly out with a screw driver and removed the old socket and placed the new one in. Whole operation to 5... read more